Pall Acrodisc Versapor Syringe Filters, 1.2 µm, 25 mm, 300/Pk - 4488
A syringe filter membrane can clog fast on viscous, difficult samples: exactly the failure mode Pall's Versapor acrylic copolymer chemistry was built to push past. A syringe filter dispenses filtrate directly into an autosampler vial, without the intermediate collection vessel a bulk vacuum filtration setup typically needs. Versapor holds absolute retention at rated pore size and clears thick samples without slowing. The polypropylene housing routes flow to minimize backpressure in service while staying inert across common laboratory solvents and preserves sample chemistry across the flow path. Where small-volume samples must reach the instrument clean, low hold-up volume keeps sample loss minimal while the instrument stays protected from particulate damage.
Membrane Characteristics
- Stable hydrophilic character persists throughout the full depth of the acrylic matrix
- Consistent, absolute pore ratings keep protocol-to-protocol results reliable
- Acrylic copolymer chemistry yields a low-extractable, analytically clean filtration surface
- Nonwoven nylon 6,6 backing adds dimensional stability under vacuum and positive pressure
- Single acrylic copolymer chemistry covers pore ratings from 0.2 to 5.0 micron
Housing Characteristics
- Polypropylene housing tolerates dilute aqueous acids, bases, and alcohols used in routine sample prep
- Low moisture absorption keeps the housing dimensionally stable through humid storage and shipping
- Withstands standard 121°C steam autoclave cycles without softening or structural distortion
- Plasticizer-free polyolefin construction keeps the fluid path clean
A particulate-laden aqueous sample makes the rest of your preparation unpredictable. Consistent aqueous clarification clears particulates without slowing your bench routine across the buffers and reagents your day-to-day prep depends on. Contact Tisch Scientific for a quote, lead time, or stock-on-hand check on your filtration product selection.
Sterilization Guidance
The housing supports customer autoclave sterilization at 121°C for 30 minutes.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 6psi
- Burst Pressure (psi)
- 75psi
- Connection Type
- Luer-Lock/ Luer Slip
- Construction
- Polypropylene (PP)
- Diameter
- 25mm
- Filtration Area
- 2.8cm²
- Flow Rate
- 660ml
- Holdup Volume
- < 100 µL
- Material
- Acrylic Copolymer
- Maximum Operating Pressure
- 75psi
- Maximum Operating Temperature (°C)
- 55°C
- Pack Count
- 300
- Pore Size (µm)
- 1.2
- Sterility
- Nonsterile
- Wettability
- Hydrophilic
- Biological Assay Support - Prepares particle-free aqueous matrices and reagent solutions for cell viability, proliferation, and toxicity studies.
- mRNA Formulation Prep - Filters aqueous lipid nanoparticle and nucleic acid formulation buffers with low adsorption to protect encapsulated cargo.
- Biopharma In-Process Monitoring - Delivers rapid inline filtration of bioprocess intermediates for turbidity, pH, and osmolality measurement.
- Flow Cytometry Buffer Prep - Filters cell sorting buffers to eliminate particulate artifacts that trigger false positive counting events.
- Serum Media Clarification - Serves as a rugged pre-filter for nutrient-rich culture media, removing aggregates ahead of downstream filters.
- Environmental Water Testing - Removes heavy sediment loads from turbid surface water and wastewater samples ahead of routine quality testing.