Pall Acrodisc PTFE Syringe Filters, 0.45 µm, 13 mm, 1000/Pk - 4543
Every Pall production lot passes through the same arc, raw membrane casting to a finished device's integrity test, before performance counts as consistent. Sample preparation for chromatography often ends with a syringe filter on the path to the vial. The hydrophobic PTFE membrane suits gas, vent, and solvent-stream filtration and filters aggressive organic solvents without breakdown. The polypropylene housing resists aqueous acids, bases, and alcohols in routine use and presses snugly against the membrane during the pass. When method reproducibility rests on consistent sample prep, syringe filtration holds that standard injection after injection.
Membrane Characteristics
- Water contact angle near 120 degrees marks strong hydrophobicity
- High membrane porosity, 70 to 80 percent void volume, delivers high flow at low pressure
- Surface energy near 18.5 dynes per centimeter repels oils and nonpolar liquids
- Node-fibril microstructure resists compaction under sustained operating pressure
- Minimal moisture absorption pairs with a low tare mass
Housing Characteristics
- Inert polyolefin wall contributes minimal sample adsorption to the filtrate
- Optimized internal geometry minimizes backpressure in service
- Withstands standard 121°C steam autoclave cycles without softening or structural distortion
- Polypropylene housing withstands rated backpressure from dense sample matrices without deformation
An aggressive solvent can leach or break down a vulnerable filter and carry debris into your prep. Solvent-stream filtration handles the solvents and reagents your methods rely on from initial prep through final use. Request a quality certificate, lot documentation, or a blanket-order quote for your filtration order at any time.
Sterilization Guidance
Customer autoclave compatibility at 121°C accommodates in-lab sterilization timing.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 9psi (IPA)
- Burst Pressure (psi)
- 100psi
- Connection Type
- Luer-Lock/ Luer Slip
- Construction
- Polypropylene (PP)
- Diameter
- 13mm
- Filtration Area
- 1.0cm²
- Holdup Volume
- < 30 µL
- Material
- Polytetrafluoroethylene (PTFE)
- Maximum Operating Pressure
- 100psi
- Maximum Operating Temperature (°C)
- 100°C
- Pack Count
- 1000
- Pore Size (µm)
- 0.45
- Sterility
- Nonsterile
- Sterilization
- Autoclavable at 121°C for 15-20 min
- Wettability
- Hydrophobic
- Ergonomic Filtration - Larger surface area reduces the hand force needed for manual filtration, helping minimize operator fatigue and strain.
- Toxicology Screening - Clarifies protein-precipitated serum, plasma, and urine extracts ahead of LC-MS or GC-MS drug screening analysis.
- Automated Sample Prep - PTFE's chemical inertness holds up through repeated robotic filtration cycles without degrading or swelling over time.
- Cryogenic Fluids - Delivers consistent performance across extreme temperature ranges, filtering cryogenic liquids with dependable, reliable results.
- Battery Electrolyte Prep - Clarifies lithium-ion battery electrolyte in carbonate solvents ahead of GC-MS purity and impurity analysis.
- Trace Metals Analysis - PTFE's low metal-extractable profile clarifies acid-digested samples for clean, low-background ICP-MS and ICP-OES results.