Pall Acrodisc Supor (PES) Syringe Filters, 0.2 µm, 25 mm, 1000/Pk - 4783
Pall validates the Supor membrane's retention at each stated pore rating, keeping biological sample clarification consistent from one production lot to the next. Sterilizing-grade syringe filters deliver sterile-grade retention as a single-use format, eliminating the autoclaving and cleaning cycle a reusable sterile filtration setup would require. The PES matrix tolerates aliphatic alcohols, glycols, and aqueous buffers and pairs fast flow with reduced protein adsorption. Thermal-bonded PP construction leaves no seam for sample to bypass the membrane and delivers a chemically clean filtrate to the downstream step. For workflows requiring validated sterile-grade performance, point-of-use retention meets it without a separate sterilization step.
Membrane Characteristics
- Absolute pore size rating holds consistent across every lot
- Sterilizing-grade PES membrane lots are challenge-tested against Brevundimonas diminuta to qualify 0.2 micron retention
- Antibody and protein samples pass through PES with minimal adsorptive loss
- Mechanical strength keeps the matrix intact under vacuum or pressure
- Aromatic sulfone backbone underlies stability across the full pH range
Housing Characteristics
- Burst pressure rating provides a wide safety margin above the rated maximum operating pressure
- Medical-grade polypropylene with broad chemical compatibility
- Housing rated for warm-sample filtration above standard laboratory temperature without softening or seal loss
- Impact-tolerant polypropylene body withstands routine bench handling without damage
Juggling several filter types for one routine clarification eats up your bench time. General-purpose aqueous filtration supports the sample types you handle every day from reagent and buffer preparation through routine sample clarification. Contact Tisch Scientific for a quote, lead time, or stock-on-hand check on your filtration product selection.
Sterilization Guidance
Standard autoclave cycles at 121°C for 30 minutes prepare the device for sterile workflows.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 51psi
- Burst Pressure (psi)
- 60psi
- Connection Type
- Luer-Lock/ Minispike
- Construction
- Polypropylene (PP)
- Diameter
- 25mm
- Filtration Area
- 3.9cm²
- Flow Rate
- 175ml
- Holdup Volume
- < 100 µL
- Material
- Polyethersulfone (PES)
- Maximum Operating Pressure
- 75psi
- Maximum Operating Temperature (°C)
- 100°C
- Pack Count
- 1000
- Pore Size (µm)
- 0.2
- Sterility
- Nonsterile
- Sterilization
- Autoclavable at 121°C for 15-20 min
- Wettability
- Hydrophilic
- Biopharmaceutical Filling - Provides a validated microbial barrier for final product filling where low protein binding supports maximum yield.
- Biological Assays - Protects sensitive enzymatic and antibody-based assays from particulate interference without adsorbing critical reagents.
- Organic Carbon Testing - Clarifies water samples ahead of DOC and UV254 analysis while keeping organic carbon adsorption to the membrane minimal.
- Sample Recovery - Minimizes sample loss in low-protein-binding applications, delivering high yield for precious or rare biological specimens.
- Pharmaceutical Quality Control - Meets regulated lab standards where housing integrity and low extractable profiles are strictly required daily.
- Robotic Line Compatibility - Pall PES filters run cleanly through automated syringe platforms without snagging, jamming, or leaking mid-run.