Tisch Scientific Polypropylene (PP) Syringe Filters, 0.45 µm, 4 mm, 100/Pk - SF18220
Tisch Scientific's product lineup extends from filtration membranes to devices and the consumable supplies laboratories use daily. A syringe filter's small hold-up volume limits sample loss, a meaningful difference when working with a limited or precious sample. The polypropylene membrane holds up to aggressive process chemistries while keeping binding low and capturing particulates through its depth and keeps water out during solvent and gas-purge steps. Low-extractable polypropylene keeps sample purity intact through the filtration pass and stays inert across common laboratory solvents. Where small-volume samples must reach the instrument clean, low hold-up volume keeps sample loss minimal while the instrument stays protected from particulate damage.
Membrane Characteristics
- Polyolefin structure resists saponification under prolonged base contact
- Wets through readily under modest differential pressure despite an inherently hydrophobic surface
- Alcohol pre-wetting opens the hydrophobic matrix to aqueous sample streams
- Halogen-free composition avoids hazardous fluorine byproducts during incineration
- Solvent-stable polypropylene handles aliphatic hydrocarbons and common process oils
Housing Characteristics
- Thermal-bonded construction keeps adhesives out of the fluid path
- Withstands ethylene oxide gas sterilization without embrittlement or structural damage
- Polypropylene housing withstands rated backpressure from dense sample matrices without deformation
- Withstands standard 121°C steam autoclave cycles without softening or structural distortion
An aggressive solvent can leach or break down a vulnerable filter and carry debris into your prep. Solvent-stream filtration handles the solvents and reagents your methods rely on from initial prep through final use. Standardize your filtration purchases across every method with volume pricing and documentation from the Tisch Scientific team.
Sterilization Guidance
Sterile single-use packaging removes any in-lab sterilization preparation step.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 7.40psi
- Connection Type
- Luer-Lok/Luer Slip
- Construction
- Polypropylene (PP)
- Diameter
- 4mm
- Filtration Area
- 0.125cm²
- Flow Rate
- 1ml
- Holdup Volume
- 1μL
- Material
- Polypropylene (PP)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 140-260μm
- Pack Count
- 100
- Pore Size (µm)
- 0.45
- Prefilter (Yes/No)
- No
- Sterility
- Sterile
- Volume Throughput (ml)
- 1ml
- Weight
- 0.33
- Wettability
- Hydrophobic
- Petrochemical Sample Prep - Handles aliphatic and light petroleum process streams for GC and GC-MS hydrocarbon speciation and quality testing.
- Hexane Extract Filtration - Handles non-polar hexane extracts from food, environmental, and pharmaceutical matrices without swelling or extractables.
- Diesel and Biodiesel Analysis - Filters fuel samples in alcohol and aliphatic solvent matrices for ASTM method compositional and purity testing.
- Polymer Solution Prep - Handles THF and alcohol polymer solutions with high loads for GPC and SEC column protection and sample clarification.
- Rubber Compound Testing - Filters cyclohexane and alcohol rubber extract solutions for antioxidant and additive content analysis by chromatography.
- Agricultural Chemical Prep - Filters herbicide and pesticide formulations in aqueous and alcohol carrier media for field and regulatory testing.