Tisch Scientific Polypropylene (PP) Syringe Filters, 5 µm, 25 mm, 100/Pk - SPEC18191
Tisch Scientific's representatives greet every caller with patience, whatever brings them to the phone. Syringe filters replace the separate holder and vacuum apparatus of bulk filtration with a single disposable unit, eliminating cleaning between samples. Low-binding polypropylene sustains throughput as a depth medium and keeps water out during solvent and gas-purge steps. Thermal-bonded PP construction leaves no seam for sample to bypass the membrane while staying inert across common laboratory solvents and preserves sample chemistry across the flow path. Where bench-scale prep must move quickly from one sample to the next, each sample starts as clean as the last without a carry-over risk or a cleaning step between uses.
Membrane Characteristics
- Nominal pore ratings span submicron prefilter grades to coarse depth configurations
- Withstands repeated steam autoclave cycles at 121°C without structural degradation
- Wets through readily under modest differential pressure despite an inherently hydrophobic surface
- Captures coarse particles near the surface and fine particles deeper within
- Halogen-free composition avoids hazardous fluorine byproducts during incineration
Housing Characteristics
- Minimal extractable release from the housing supports sensitive analytical work downstream
- Resists stress cracking from aqueous salt and buffer solutions
- Impact-tolerant polypropylene body withstands routine bench handling without damage
- Rigid polypropylene body maintains its geometry through routine filtration pressure
Particulates left in your organic solvents and reagents carry downstream into the step that depends on a clean feed. Solvent-stream filtration handles the solvents and reagents your methods rely on so your filter holds its integrity through the run. Request a quality certificate, lot documentation, or a blanket-order quote for your filtration order at any time.
Sterilization Guidance
Standard autoclave cycles at 121°C for 30 minutes prepare the device for sterile workflows.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- NA
- Burst Pressure (psi)
- 116psi
- Connection Type
- Double Luer Lock
- Construction
- Polypropylene (PP)
- Diameter
- 25mm
- Dimensions (W x D x H)
- 21.8mmx28.6mm
- Filtration Area
- 4.9 cm²
- Incompatibility
- Esters, hexane, toluene, benzene, dichloromenthan
- Material
- Polypropylene (PP)
- Maximum Operating Pressure
- 72.5psi
- Maximum Operating Temperature (°C)
- 80℃
- Pack Count
- 100
- Pore Size (µm)
- 5.0
- Sterility
- Nonsterile
- Sterilization
- Autoclave: 121°C for 30 minutes/ Gamma: 5kg, for 8 hours
- Weight
- 0.58
- Wettability
- Hydrophobic
- Metal Plating Bath Testing - Filters acidic plating bath solutions for ICP-OES and voltammetric quantitation of metal ion concentrations.
- Flavor and Fragrance Prep - Handles alcohol-based flavor and fragrance concentrate preparations before GC-MS aroma compound profiling.
- Alcohol Solution Filtration - Clarifies methanol, ethanol, and isopropanol solutions for HPLC and GC analysis without swelling.
- Industrial Solvent Monitoring - Clarifies organic solvent process streams and used-solvent recovery batches for quality and contamination analysis.
- Petrochemical Sample Prep - Handles aliphatic and light petroleum process streams for GC and GC-MS hydrocarbon speciation and quality testing.
- Diesel and Biodiesel Analysis - Filters fuel samples in alcohol and aliphatic solvent matrices for ASTM method compositional and purity testing.