Tisch Scientific PTFE Syringe Filters, 0.22 µm, 33 mm, 100/Pk - SF14476
Tisch Scientific's product lineup extends from filtration membranes to devices and the consumable supplies laboratories use daily. Gas and vent service calls for a hydrophobic syringe filter rated to the same sterilizing-grade pore size as its liquid counterpart. The hydrophobic PTFE membrane suits gas, vent, and solvent-stream filtration while suiting solvent filtration where other membranes fail and resists attack from the harshest process chemistries. Pre-sterilized polypropylene construction is individually wrapped for direct use in sterile workflows while leaving no seam for sample to bypass the membrane and resists degradation from routine sample matrices. No separate sterilization cycle is needed when the gas path already runs through a validated sterile-grade membrane.
Membrane Characteristics
- Validated against an aerosol Brevundimonas diminuta bacterial challenge
- High porosity minimizes hold-up volume for small sample volumes
- Insolubility in all known organic solvents avoids swelling and pore distortion
- Gas-venting and liquid-blocking function survives repeated autoclave sterilization cycles
- Low non-specific protein binding preserves recovery of biomolecules and therapeutic proteins during filtration
Housing Characteristics
- Thermal-bonded construction keeps adhesives out of the fluid path
- Translucent housing wall allows visual confirmation of sample flow during filtration
- Minimal intrinsic autofluorescence from the polypropylene housing supports background-sensitive fluorescence-based assay work downstream
- Housing rated for reliable filtration under syringe-applied backpressure at its maximum operating pressure
A filter that softens or swells in your solvent fails you mid-run, batch after batch. Solvent-stream filtration handles the solvents and reagents your methods rely on from initial prep through final use. Request details on payment terms or standing-order arrangements for your routine filtration purchases.
Sterilization Guidance
The device arrives factory sterile and is intended for single-use sample preparation.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 17.4(absolute ethyl alcohol)
- Burst Pressure (psi)
- 87psi.
- Connection Type
- Luer-Lok/Luer Slip
- Construction
- PP
- Diameter
- 33mm
- Filtration Area
- 4.6cm²
- Flow Rate
- 29.5ml
- Holdup Volume
- 100μL
- Incompatibility
- Aqueous samples without rewetting
- Material
- Polytetrafluoroethylene (PTFE)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 80-140μm
- Pack Count
- 100
- Pore Size (µm)
- 0.22
- Sterility
- Sterile
- Volume Throughput (ml)
- 120ml
- Weight
- 1.40
- Wettability
- Hydrophobic
- Spirits Congener Analysis - Clarifies distilled spirits samples ahead of GC analysis, protecting columns from residue during congener profiling.
- Photoresist Filtration - Clarifies photoresist solutions in organic casting solvent ahead of spin-coating, reducing particulate defect risk.
- Air Monitoring - Ensures precise capture of airborne particulates for environmental analysis in demanding atmospheric monitoring conditions.
- Aggressive Solvents - Clarifies chlorinated hydrocarbons and aromatics without membrane degradation, delivering pure filtrate quality consistently.
- Dye and Pigment Analysis - Clarifies dye solutions in DMF, NMP, and other aggressive organics ahead of spectrophotometric color strength testing.
- Extractables Testing - Clarifies packaging material organic solvent extracts ahead of LC-MS analysis, keeping background low for leachable detection.