Tisch Scientific PTFE Syringe Filters, 0.45 µm, 17 mm, 100/Pk - SF18242
Tisch Scientific's representatives greet every caller with patience, whatever brings them to the phone. A syringe filter's small hold-up volume limits sample loss, a meaningful difference when working with a limited or precious sample. The PTFE matrix handles concentrated acids and bases across demanding methods and repels water while passing gases and solvents freely. The PP housing stays inert across common laboratory solvents and buffers in routine use and ships pre-sterilized with individual packaging for aseptic filtration workflows. Where analytical results depend on clean samples, the preparation step stays consistent from sample to sample through a pre-tested syringe filter.
Membrane Characteristics
- Low non-specific protein binding preserves recovery of biomolecules and therapeutic proteins during filtration
- Absolute pore rating delivers reproducible retention across every protocol
- High membrane porosity, 70 to 80 percent void volume, delivers high flow at low pressure
- Chemical resistance spans the full pH 1 to 14 range
- Strong oxidizing agents like nascent chlorine and concentrated sodium hydroxide cause no attack
Housing Characteristics
- Polypropylene housing withstands rated backpressure from dense sample matrices without deformation
- Medical-grade polypropylene with broad chemical compatibility
- Optimized internal geometry minimizes backpressure in service
- Polypropylene housing retains its chemical integrity under vaporized hydrogen peroxide decontamination cycles used in aseptic processing isolators
Particulates left in your organic solvents and reagents carry downstream into the step that depends on a clean feed. Reliable solvent prefiltration keeps a stray particulate from carrying into your downstream work before it carries into further processing. Request blanket-order pricing and paperwork support for your routine filtration purchases.
Sterilization Guidance
Sterile single-use packaging removes any in-lab sterilization preparation step.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 7.25psi (absolute ethyl alcohol)
- Burst Pressure (psi)
- 87psi.
- Connection Type
- Luer-Lok/Luer Slip
- Construction
- Polypropylene (PP)
- Diameter
- 17mm
- Filtration Area
- 1.65cm²
- Flow Rate
- 20ml
- Holdup Volume
- 20μL
- Incompatibility
- Aqueous samples without rewetting
- Material
- Polytetrafluoroethylene (PTFE)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 80-140μm
- Pack Count
- 100
- Pore Size (µm)
- 0.45
- Sterility
- Sterile
- Volume Throughput (ml)
- 20ml
- Weight
- 0.70
- Wettability
- Hydrophobic
- Photoresist Filtration - Clarifies photoresist solutions in organic casting solvent ahead of spin-coating, reducing particulate defect risk.
- Fuel Analysis Prep - Clarifies gasoline and other petroleum samples ahead of gas chromatography, protecting injector ports from residue buildup.
- Dissolution Testing - Stops the dissolution reaction and clarifies samples, with low API binding for accurate potency quantitation.
- Aggressive Solvents - Clarifies chlorinated hydrocarbons and aromatics without membrane degradation, delivering pure filtrate quality consistently.
- Agrochemical Formulation QC - Clarifies technical pesticide concentrates in organic solvent ahead of HPLC potency and impurity analysis.
- Polymer GPC Prep - Clarifies polymer solutions in THF ahead of gel permeation chromatography, protecting columns from particulates.