Tisch Scientific PTFE Syringe Filters, 5 µm, 25 mm, 100/Pk - SF18251
Tisch Scientific vets its filtration partners carefully, favoring those with a consistent record of dependable output. Sample preparation for chromatography often ends with a syringe filter on the path to the vial. PTFE delivers absolute particle cutoff at the rated pore size and repels water while passing gases and solvents freely. Polyolefin construction sheds virtually no extractable material into the sample while pressing snugly against the membrane during the pass and sustains efficient flow on viscous samples. Where bench-scale prep must move quickly from one sample to the next, each sample starts as clean as the last without a carry-over risk or a cleaning step between uses.
Membrane Characteristics
- Water contact angle near 120 degrees marks strong hydrophobicity
- Fully fluorinated carbon backbone resists ultraviolet and ozone degradation
- Chemical resistance spans the full pH 1 to 14 range
- Low extractables keep the chromatographic background clean
- Strong oxidizing agents like nascent chlorine and concentrated sodium hydroxide cause no attack
Housing Characteristics
- Sterile barrier packaging assures the housing's factory-sterilized state is intact at the point of use
- Each housing is factory-sterilized and sealed individually to maintain sterility through the supply chain
- Minimal intrinsic autofluorescence from the polypropylene housing supports background-sensitive fluorescence-based assay work downstream
- Plasticizer-free polyolefin construction keeps the fluid path clean
A filter that softens or swells in your solvent fails you mid-run, batch after batch. Solvent-stream filtration handles the solvents and reagents your methods rely on across the organic solvents and harsh reagents your methods use. Reach out to the Tisch Scientific team about minimum order quantities and shipping timelines for your filtration product selection.
Sterilization Guidance
The device arrives factory sterile and is intended for single-use sample preparation.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 1.45(absolute ethyl alcohol)
- Burst Pressure (psi)
- 87psi.
- Connection Type
- Luer-Lok/Luer Slip
- Construction
- PP
- Diameter
- 25mm
- Filtration Area
- 4.08cm²
- Flow Rate
- 240ml
- Holdup Volume
- 100μL
- Incompatibility
- Aqueous samples without rewetting
- Material
- Polytetrafluoroethylene (PTFE)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 80-140μm
- Pack Count
- 100
- Pore Size (µm)
- 5.0
- Sterility
- Sterile
- Volume Throughput (ml)
- 100ml
- Weight
- 0.88
- Wettability
- Hydrophobic
- Pump Protection - Acts as a hydrophobic barrier that protects vacuum pumps from corrosive moisture and particulate damage.
- Extractables Testing - Clarifies packaging material organic solvent extracts ahead of LC-MS analysis, keeping background low for leachable detection.
- Dye and Pigment Analysis - Clarifies dye solutions in DMF, NMP, and other aggressive organics ahead of spectrophotometric color strength testing.
- Agrochemical Formulation QC - Clarifies technical pesticide concentrates in organic solvent ahead of HPLC potency and impurity analysis.
- Dissolution Testing - Stops the dissolution reaction and clarifies samples, with low API binding for accurate potency quantitation.
- Aggressive Solvents - Clarifies chlorinated hydrocarbons and aromatics without membrane degradation, delivering pure filtrate quality consistently.