Tisch Scientific PVDF Syringe Filters, 0.45 µm, 13 mm, 100/Pk - SF14461
Tisch Scientific's product lineup extends from filtration membranes to devices and the consumable supplies laboratories use daily. Syringe filters span a wide range of membrane chemistries and pore sizes, so the format can be matched to the sample matrix and solvent system in use. PVDF resists HPLC mobile phases, alcohols, and mild hydrocarbons and clarifies samples at the rated pore size. Polyolefin construction sheds virtually no extractable material into the sample while holding its seal true run after run and routes flow to minimize backpressure in service. Where analytical results depend on clean samples, the preparation step stays consistent from sample to sample through a pre-tested syringe filter.
Membrane Characteristics
- Low ionic extractables preserve baseline stability in conductivity-based ion chromatography detection
- Hydrophobic surface chemistry gives PVDF a water contact angle above 100 degrees, blocking wetting
- Ethylene oxide sterilization cycles leave pore integrity and flow performance intact
- Fluorinated polymer chemistry resists ozone, UV, and ionizing radiation
- Cast membrane structure releases no fibers, unlike depth-media prefilters
Housing Characteristics
- PP housing supplied sterile in individual packaging for immediate use in aseptic filtration without bench preparation
- Optimized internal geometry minimizes backpressure in service
- Withstands ethylene oxide gas sterilization without embrittlement or structural damage
- Rigid polypropylene body maintains its geometry through routine filtration pressure
An aggressive solvent can leach or break down a vulnerable filter and carry debris into your prep. Solvent-stream filtration handles the solvents and reagents your methods rely on so your filter holds its integrity through the run. Standardize your filtration purchases across every method with volume pricing and documentation from the Tisch Scientific team.
Sterilization Guidance
Sterile single-use packaging removes any in-lab sterilization preparation step.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 5.8psi
- Connection Type
- Luer-Lok/Luer Slip
- Diameter
- 13mm
- Filtration Area
- 1.09cm²
- Flow Rate
- 8ml
- Holdup Volume
- 10μL
- Material
- Polyvinylidene Fluoride (PVDF)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 100-130μm
- Pack Count
- 100
- Pore Size (µm)
- 0.45
- Prefilter (Yes/No)
- Yes
- Prefilter Material
- PP
- Sterility
- Sterile
- Volume Throughput (ml)
- 10ml
- Weight
- 0.40
- Wettability
- Hydrophobic
- Compressed Gas Filtration - Passes nitrogen and other inert gases freely while holding back moisture, protecting instruments and gas lines.
- Organic Solvent Filtration - Wets readily with alcohols and mild hydrocarbons, delivering dependable clarification of organic solvent samples.
- Vial and Tubing Venting - Blocks liquid while venting sealed vials and tubing lines, keeping pressure equalized during fluid transfer steps.
- Bioreactor Vent Protection - Repels water while venting bioreactors and fermenters, keeping process air and gases moving freely through the line.
- Dissolution Testing - Removes undissolved particles from timed USP 711 dissolution aliquots, preventing skewed potency and release results.
- Culture Vessel Filling - Equalizes pressure in sealed culture vessels by venting displaced air, keeping fill and drain lines fully closed.