Tisch Scientific PVDF Syringe Filters, 0.45 µm, 17 mm, 100/Pk - SF18222
Tisch Scientific's representatives greet every caller with patience, whatever brings them to the phone. A syringe filter dispenses filtrate directly into an autosampler vial, without the intermediate collection vessel a bulk vacuum filtration setup typically needs. The PVDF membrane clarifies samples at the rated pore size while holding up to alcohols and mild hydrocarbon solvents and repels water for dependable gas and vent filtration. The polypropylene housing holds its seal true run after run and stays inert across common laboratory solvents. For routine sample preparation across many methods, each analytical run starts with a consistent, particle-free sample without added hardware or a cleaning step.
Membrane Characteristics
- Hydrophobic surface supports sterile venting of air and process gases
- Hydrochloric, dilute nitric, and up to 90% sulfuric acid cause no attack
- Chemical compatibility spans the full pH 1 to 14 range
- Organic solvent resistance beats PES or nylon at comparable pore size
- Ethylene oxide sterilization cycles leave pore integrity and flow performance intact
Housing Characteristics
- Sterile barrier packaging assures the housing's factory-sterilized state is intact at the point of use
- Polypropylene housing tolerates ethylene oxide gas sterilization cycles without softening or dimensional distortion
- Rated operating pressure supports filtration of high-resistance and viscous samples without housing distortion
- Withstands standard 121°C steam autoclave cycles without softening or structural distortion
A filter that softens or swells in your solvent fails you mid-run, batch after batch. Solvent-stream filtration handles the solvents and reagents your methods rely on from initial prep through final use. Request available pack sizes and lead times across this filtration line's membrane options from the Tisch Scientific team.
Sterilization Guidance
Factory sterilization supports immediate use in workflows where sterility assurance matters.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 5.8psi
- Connection Type
- Luer-Lok/Luer Slip
- Diameter
- 17mm
- Filtration Area
- 1.65cm²
- Flow Rate
- 12ml
- Holdup Volume
- 20μL
- Material
- Polyvinylidene Fluoride (PVDF)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 100-130μm
- Pack Count
- 100
- Pore Size (µm)
- 0.45
- Prefilter (Yes/No)
- Yes
- Prefilter Material
- PP
- Sterility
- Sterile
- Volume Throughput (ml)
- 20ml
- Weight
- 0.70
- Wettability
- Hydrophobic
- Compressed Gas Filtration - Passes nitrogen and other inert gases freely while holding back moisture, protecting instruments and gas lines.
- Dissolution Testing - Removes undissolved particles from timed USP 711 dissolution aliquots, preventing skewed potency and release results.
- Culture Vessel Filling - Equalizes pressure in sealed culture vessels by venting displaced air, keeping fill and drain lines fully closed.
- QuEChERS Extract Prep - Removes co-extracted waxes and pigments from QuEChERS extracts, protecting GC-MS and LC-MS systems during pesticide testing.
- Bioreactor Vent Protection - Repels water while venting bioreactors and fermenters, keeping process air and gases moving freely through the line.
- Petroleum Sample Prep - Removes particulates from fuel and lubricant samples ahead of viscosity and quality-control testing.