Tisch Scientific PVDF Syringe Filters, 0.22 µm, 30 mm, 100/Pk - SF18224
Tisch Scientific vets its filtration partners carefully, favoring those with a consistent record of dependable output. Each hydrophobic vent-rated filter carries manufacturer bacterial retention testing built into the design, letting a vent line stay in continuous service without repeating that testing on site between uses. The PVDF membrane delivers bacterial retention at the rated pore size while blocking aqueous ingress in venting applications and holds up to alcohols and mild hydrocarbon solvents. Polyolefin construction sheds virtually no extractable material into the sample while holding its seal true run after run and resists degradation from routine sample matrices. A vent or gas line stays free of airborne bacteria once a hydrophobic, sterilizing-grade membrane is in the path.
Membrane Characteristics
- Hydrophobic surface supports sterile venting of air and process gases
- Autoclave sterilization cycles leave pore structure and flow performance intact
- Limiting oxygen index runs high, supporting flame resistance and low smoke
- Mechanically durable membrane holds integrity under filtration pressure
- Low ionic extractables preserve baseline stability in conductivity-based ion chromatography detection
Housing Characteristics
- Thermal-bonded construction keeps adhesives out of the fluid path
- Each housing is factory-sterilized and sealed individually to maintain sterility through the supply chain
- Withstands ethylene oxide gas sterilization without embrittlement or structural damage
- Plasticizer-free polyolefin construction keeps the fluid path clean
A filter that softens or swells in your solvent fails you mid-run, batch after batch. Solvent-stream filtration handles the solvents and reagents your methods rely on so your filter holds its integrity through the run. Request a quality certificate, lot documentation, or a blanket-order quote for your filtration order at any time.
Sterilization Guidance
Factory sterilization supports immediate use in workflows where sterility assurance matters.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 14.5psi
- Connection Type
- Luer-Lok/Luer Slip
- Diameter
- 30mm
- Filtration Area
- 4.9cm²
- Flow Rate
- 24.5ml
- Holdup Volume
- 100μL
- Material
- Polyvinylidene Fluoride (PVDF)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 100-130μm
- Pack Count
- 100
- Pore Size (µm)
- 0.22
- Prefilter (Yes/No)
- Yes
- Prefilter Material
- PP
- Sterility
- Sterile
- Volume Throughput (ml)
- 110ml
- Weight
- 1.40
- Wettability
- Hydrophobic
- Bioreactor Vent Protection - Repels water while venting bioreactors and fermenters, keeping process air and gases moving freely through the line.
- Dissolution Testing - Removes undissolved particles from timed USP 711 dissolution aliquots, preventing skewed potency and release results.
- Beverage QC - Clarifies wine, beer, and juice samples ahead of HPLC testing for organic acids, sugars, and preservatives.
- Organic Solvent Filtration - Wets readily with alcohols and mild hydrocarbons, delivering dependable clarification of organic solvent samples.
- Compressed Gas Filtration - Passes nitrogen and other inert gases freely while holding back moisture, protecting instruments and gas lines.
- Vial and Tubing Venting - Blocks liquid while venting sealed vials and tubing lines, keeping pressure equalized during fluid transfer steps.