Tisch Scientific PVDF Syringe Filters, 0.45 µm, 4 mm, 100/Pk - SF18226
Tisch Scientific holds its filtration pricing at levels that let budget-conscious laboratories stretch procurement dollars further. Syringe filters span a wide range of membrane chemistries and pore sizes, so the format can be matched to the sample matrix and solvent system in use. PVDF holds up to alcohols and mild hydrocarbon solvents while clarifying samples at the rated pore size and passes gases freely while holding back water. The polypropylene housing preserves sample chemistry across the flow path while routing flow to minimize backpressure in service and ships pre-sterilized with individual packaging for aseptic filtration workflows. When method reproducibility rests on consistent sample prep, syringe filtration holds that standard injection after injection.
Membrane Characteristics
- Hydrophobic surface supports sterile venting of air and process gases
- Limiting oxygen index runs high, supporting flame resistance and low smoke
- Ethylene oxide sterilization cycles leave pore integrity and flow performance intact
- Gamma irradiation sterilization causes no chain scission unlike polypropylene membranes
- Autoclave sterilization cycles leave pore structure and flow performance intact
Housing Characteristics
- Impact-tolerant polypropylene body withstands routine bench handling without damage
- Minimal extractable release from the housing supports sensitive analytical work downstream
- Rated operating pressure supports filtration of high-resistance and viscous samples without housing distortion
- Rigid polypropylene body maintains its geometry through routine filtration pressure
A filter that softens or swells in your solvent fails you mid-run, batch after batch. Solvent-stream filtration handles the solvents and reagents your methods rely on so your filter holds its integrity through the run. Request available pack sizes and lead times across this filtration line's membrane options from the Tisch Scientific team.
Sterilization Guidance
Factory sterilization supports immediate use in workflows where sterility assurance matters.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 5.8psi
- Connection Type
- Luer-Lok/Luer Slip
- Diameter
- 4mm
- Filtration Area
- 0.125cm²
- Flow Rate
- 1ml
- Holdup Volume
- 1μL
- Material
- Polyvinylidene Fluoride (PVDF)
- Maximum Operating Pressure
- 87psi
- Maximum Operating Temperature (°C)
- 60°C
- Membrane Thickness (µm)
- 100-130μm
- Pack Count
- 100
- Pore Size (µm)
- 0.45
- Prefilter (Yes/No)
- Yes
- Prefilter Material
- PP
- Sterility
- Sterile
- Volume Throughput (ml)
- 1ml
- Weight
- 0.33
- Wettability
- Hydrophobic
- Culture Vessel Filling - Equalizes pressure in sealed culture vessels by venting displaced air, keeping fill and drain lines fully closed.
- Bioreactor Vent Protection - Repels water while venting bioreactors and fermenters, keeping process air and gases moving freely through the line.
- Vial and Tubing Venting - Blocks liquid while venting sealed vials and tubing lines, keeping pressure equalized during fluid transfer steps.
- Petroleum Sample Prep - Removes particulates from fuel and lubricant samples ahead of viscosity and quality-control testing.
- QuEChERS Extract Prep - Removes co-extracted waxes and pigments from QuEChERS extracts, protecting GC-MS and LC-MS systems during pesticide testing.
- Robust Particulate Filtration - Withstands high pressure differentials while handling heavy particulate loads, extending membrane service life.