Tisch Scientific PVDF Syringe Filters, 0.22 µm, 25 mm, 100/Pk - SPEC18212
Tisch Scientific's product lineup extends from filtration membranes to devices and the consumable supplies laboratories use daily. Each hydrophobic vent-rated filter carries manufacturer bacterial retention testing built into the design, letting a vent line stay in continuous service without repeating that testing on site between uses. The PVDF membrane tolerates common chromatography solvents without degradation while stopping bacteria at its finest sub-micron ratings and blocks aqueous ingress in venting applications. The polypropylene housing routes flow to minimize backpressure in service while shedding virtually no extractable material into the sample and leaves no seam for sample to bypass the membrane. No separate sterilization cycle is needed when the gas path already runs through a validated sterile-grade membrane.
Membrane Characteristics
- Vapor-phase hydrogen peroxide decontamination cycles leave the membrane intact
- Low ionic extractables preserve baseline stability in conductivity-based ion chromatography detection
- Hydrophobic surface supports sterile venting of air and process gases
- Gamma irradiation sterilization causes no chain scission unlike polypropylene membranes
- Resistance to hydrolytic degradation exceeds that of nylon membranes
Housing Characteristics
- Low moisture absorption keeps the housing dimensionally stable through humid storage and shipping
- Standardized luer connection geometry provides secure engagement with standard syringe tips
- Thermal-bonded construction keeps adhesives out of the fluid path
- Sterile barrier packaging assures the housing's factory-sterilized state is intact at the point of use
An aggressive solvent can leach or break down a vulnerable filter and carry debris into your prep. Solvent-stream filtration handles the solvents and reagents your methods rely on so your filter holds its integrity through the run. Request details on payment terms or standing-order arrangements for your routine filtration purchases.
Sterilization Guidance
The device arrives factory sterile and is intended for single-use sample preparation.
For more information about chemical compatibility, please review our Chemical Compatibility Chart.
- Bubble Point (psi)
- 7.25psi
- Burst Pressure (psi)
- 116psi
- Connection Type
- Double Luer Lock
- Construction
- Polypropylene (PP)
- Diameter
- 25mm
- Dimensions (W x D x H)
- 21.8mmx28.6mm
- Filtration Area
- 4.9cm²
- Material
- Polyvinylidene Fluoride (PVDF)
- Maximum Operating Pressure
- 72.5psi
- Maximum Operating Temperature (°C)
- 80℃
- Pack Count
- 100
- Pore Size (µm)
- 0.22
- Sterility
- Sterile
- Weight
- 0.70
- Wettability
- Hydrophobic
- Dissolution Testing - Removes undissolved particles from timed USP 711 dissolution aliquots, preventing skewed potency and release results.
- Sterile Tank Venting - Blocks aqueous ingress on storage tanks and carboys, letting sterile air and gas pass through the vent line.
- Compressed Gas Filtration - Passes nitrogen and other inert gases freely while holding back moisture, protecting instruments and gas lines.
- QuEChERS Extract Prep - Removes co-extracted waxes and pigments from QuEChERS extracts, protecting GC-MS and LC-MS systems during pesticide testing.
- Culture Vessel Filling - Equalizes pressure in sealed culture vessels by venting displaced air, keeping fill and drain lines fully closed.
- Vial and Tubing Venting - Blocks liquid while venting sealed vials and tubing lines, keeping pressure equalized during fluid transfer steps.